Eye Beams Posted April 18, 2011 Share Posted April 18, 2011 (edited) Another "Knights Contract" tip brought to you by optimus_crime101 Want to proceed to the QTE sequence for Faust (2nd Form) after he falls down the first time? Primarily for Witchslayer mode only... Mag Mell's Rose III (MMR) Vlad's Impaler III (VI) Elizabeth's Fangs (EF) Tannhauser's Illusion (TI) (crucial skill) Equips: Seal of Magic and Wisdom Save your full witch power from his 1st form! Start off by assaulting any of his legs with all 4 skills, but not in unison--cast them independently; it will prevent him from using his holy light attacks, partially "stun-locking" him. You should also be using scythe attacks (I usually go with :square:) in between each skill to re-cycle them quicker. Sometimes MMR entangles him for a while, sometimes it does not. Move on to another leg when he activates the shields, which is inevitable. After enough hits, he'll fall down, allowing you to exploit his weak point. Try to be in the front when this happens or you'll have to spend time circling around. Also, TI should already be refreshed at this point. The reason I didn't use Spirit Cannon is because you waste time making distance and have to run all the way back to him. Hop on top of him and cast EF/TI, spam :square: or , cast EF everytime it refreshes, and watch the fireworks; repeat this even when TI's short duration runs out. Do not invoke a Finsher or else he'll automatically stand back up. He has 7 health bars (roughly 6.5 after falling once); with the aforementioned combo you can deplete 4.5-5 bars alone. When the third-to-last bar (yellow-green) is over 50% gone, use Witch's Embrace to take out the remaining 2.5 bars and skip to the QTE's. Owned. Alternatives: - Starting off with Witch's Embrace should not make a huge difference. - Trap III may be good, but Faust can jump away from it, rendering it useless. (if you happen to fail during the QTE, you will die, and your witch power will be full again after you continue) Previous Tip: Cheap Trick (maybe) for Witchslayer QTE's Edited April 19, 2011 by Eye Beams Link to comment Share on other sites More sharing options...
demonslayerQ Posted May 2, 2011 Share Posted May 2, 2011 thanks for the tip, i tried it out and it totally works, was wondering on how to bring him down easier. now if only i could get the button mashing to work Link to comment Share on other sites More sharing options...
DarkAmon Posted July 13, 2011 Share Posted July 13, 2011 are the QTE's that badly glitched that they do not respond to the button presses?? i get the timing PERFECT but it says i missed and it is always on the same ones always. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now